Rexroth Hydraulic Piston Pump A4csg 250/355/500/750 and Spare Parts

• Customization: Available
• Structure: Axial Plunger Pump
• Cylinder Number: Single Cylinder
• Model NO.: A4CSG250/355/500/750
• Pump Shaft Position: Horizontal
• Type: Radial
• Power: Hydraulic
• Straight Shaft Swashplate Piston Type: Pressureoil
• Radial Plunger Pump Type: Axial Flow
• Transport Package: Standard Export Wooden Case
• Specification: A8VO 55/80/107/140/200
• Trademark: Ouster
• Origin: Made in China
• HS Code: 8413503190
• Production Capacity: 1000pieces/Year

Product Description

Product number	Specification	Working pressure	Characteristic
A4CSG	250,355,500,750	common pressure: 350 bar, peak pressure: 400 bar.	Axialpiston pump-variable displacement, swashplate design for hydrostatic drives in closed circuits. The flow is proportional to input speed and displacement. It can be infinitely varied by adjustment of the swashplate. The necessary boostpump and all required controlvalves are integrated. One common auxiliary pump for boost and EP-control pressure Compact design (extremely small in length) Favourable power to weight ratio Low noise level,Long service life,High efficiency                                        New electro-hydr. control EP with proportional solenoid and zero displacement position at power loss                                                  Throughdrive for multiple pumpcombinations also possible with integrated boost pump
Security instructions
1, A4CSG pump is designed for use in closed loop oil circuit.  Variable displacement axial piston pump designed with swashplate is suitable for hydraulic transmission in closed circuit. Flow is proportional to input speed and displacement. By adjusting the inclined plate, it can be adjusted infinitely.
2,The required auxiliary pumps and all necessary control valves are integrated. - A common auxiliary pump for boosting and EP pressure control Compact design (very short length) Reasonable power/weight ratio Low Noise Level Long service life High efficiency New electro-hydraulic control EP with proportional coil and zero displacement position (power loss time) Multi-pump combination of shaft drive can also be used for integrated auxiliary pumps
3,The pump A4CSG is designed to operate in closed circuit.                                                 System design, installation and commissioning need to be performed by trained technicians and distributors.                                All hydraulic orifices can only be used to tighten hydraulic maintenance pipelines.
Tightening Torque
1,Please follow the manufacturer's information on the maximum allowable tightening torque of the fittings used.
2,For DIN 13-compliant fastening screws, it is recommended that the allowable tightening torque be checked in all cases according to VDI 2230 (released in 2003).
3,During or shortly after the operation of the pump, the shell, especially the coil, may be extremely hot to avoid scalding!
Installation Notes:
1,During commissioning and operation, oil must be injected into the pump housing. It must be debugged at low speed and without load until the system is completely degassed.
2,If it stays stationary for a long time, the shell will leak through the repair pipeline. When restarting, oil must be re-injected into the pump housing. The inlet pressure at the suction port S should not be less than 0.8 bar (absolute)
Optional:
1,To achieve a low noise level, all hydraulic pipes (oil suction, pressure and discharge pipes) should be connected to the tank through flexible fittings.
2,The use of one-way valves in pump drainage pipes should be avoided. If necessary, please contact us.